TV Mounting Cost in Calgary (2026)

Typical price range in Calgary (2026)

Most standard TV mounts in Calgary start around $95 for a fixed mount, $115 for a tilt mount and $135 for a full-motion mount on drywall with wood studs. That covers the installation, stud locating, levelling and basic surface cable tuck. The mount itself is customer-supplied.

A soundbar bracket added on the same visit typically runs an additional $45.

Be cautious of quotes under $75 — they often exclude cable management, assume ideal stud positions or apply surge pricing on the day. A quote that requires photos before confirming the price is more reliable than one given by phone with no information about the wall.

What drives the price up

Full-motion mount

Full-motion (articulating or swing-arm) mounts let the TV rotate, tilt and extend from the wall. They require more hardware, heavier brackets and longer installation time — the arm itself must be assembled and the extension stops set so the TV does not overextend and stress the wall anchors. Full-motion mounts always require stud mounting; they put lateral stress on the anchors when extended that drywall anchors cannot handle safely over time.

Concrete or brick wall

Mounting into concrete block, poured concrete or brick requires a hammer drill and masonry anchors. The drilling takes longer, the anchors are heavier-duty and there is no such thing as “just shift it 2 inches to hit a stud.” The position is fixed by the anchor pattern. Expect $25–$50 added to the base price and confirm when requesting a quote by sending a photo of the wall.

Above-fireplace install

Mounting above a fireplace is one of the most common TV mounting requests in Calgary — and one of the more nuanced. See the dedicated section below.

Cable management

Surface cable management — running cables along the wall with a raceway or clip system — is included in the standard service. In-wall cable routing (running HDMI and power cables through the wall cavity so nothing is visible) is a separate job that involves cutting drywall, routing through the wall and patching — it is not included in the TV mounting price and should be quoted separately as a combined TV mounting and drywall visit.

Note: routing a power outlet inside the wall requires an electrician. A handyman can route HDMI and component cables through a wall; a power extension inside drywall must be done by a licensed electrician. Most Calgary homeowners solve this with a recessed power outlet kit installed by an electrician before the TV mounting visit, or by using a surface power cable raceway.

Large or heavy TV (75"+)

TVs 65 inches and larger — which typically weigh 45 to 80 lbs — require stud mounting. A 75-inch TV with a full-motion mount puts significant cantilever load on the wall when extended. Stud spacing (typically 16 or 24 inches on centre in Calgary homes) needs to align with the mount's VESA bracket pattern. For very large TVs, a handyman may need to shift the mount position slightly from the ideal spot to hit both studs cleanly.

Soundbar mounting

A soundbar bracket mounts directly below or above the TV on the same wall, typically 3 to 5 inches below the screen. It is a straightforward add-on that takes about 20 minutes. If the soundbar came with a wall-mount kit, have it out of the box. If it did not, a universal soundbar shelf bracket (available at Best Buy, Costco, Amazon) is the simplest solution.

Above-fireplace TV mounting in Calgary

The above-fireplace install is the single most common TV mounting scenario in Calgary new builds — the large feature wall above a gas fireplace is designed for a TV, and most Calgary homes built after 2005 have a power outlet already roughed into that wall location.

What makes it different

• Height — the TV ends up higher than ideal for seated viewing. The centre of screen is often 60 to 70 inches from the floor rather than the preferred 42 to 48 inches. A tilt mount is not optional here — it is mandatory for comfortable viewing without neck strain.
• Heat — gas fireplaces produce heat that rises toward the TV. Confirm there is at least 12 inches of clearance between the top of the firebox insert and the bottom of the TV, and that the fireplace is not a high-heat radiant unit. Wood-burning fireplaces produce too much heat for most TV installations above them.
• Studs and blocking — many Calgary builders install blocking (horizontal lumber) in the feature wall specifically for a TV mount. If your wall has blocking, it will be visible when you take a wide photo of the wall: look for a horizontal line in the drywall or a row of finished screws at TV height. Blocking means secure mounting anywhere in that zone regardless of stud position.
• Cable routing — the roughed-in power outlet at TV height usually has a corresponding low-voltage rough-in below the fireplace for cable routing. Ask a handyman to confirm this exists before booking — if it is there, cables can be routed cleanly without drywall work.

Above-fireplace install pricing

An above-fireplace install with a tilt mount and surface cable management starts around $135–$155. If the blocking is already in place, the install is as fast as a standard wall mount. If the wall requires masonry anchors into a stone or tile surround, add $25–$50.

DIY vs hiring a handyman in Calgary

DIY makes sense if you have accessible studs confirmed with a stud finder, a power drill, a level, a second person to hold the TV while you hang it, and the mount instructions are clear. A standard 55-inch TV on a fixed mount on drywall with accessible studs is manageable for most people with basic tools and patience.

Hire a handyman if you are mounting above a fireplace, on concrete, need a full-motion mount, want cables hidden, have a TV 65 inches or larger, or simply do not want to risk a crooked or insecure install. A 65-inch TV weighs 50+ lbs — a poorly placed anchor or a missed stud is a significant safety risk and an expensive repair if the TV falls.

The most common DIY failure modes in Calgary:

• Mounting into hollow wall — no stud, wrong anchor — a standard plastic toggle anchor rated for 30 lbs will eventually pull free from the vibration of a soundbar over months. Heavy-duty flip-toggle bolts or Snaptoggle anchors are the correct backup when studs are not available.
• Mounting at the wrong height — common in bedrooms (too high for comfortable viewing from a pillow) and above fireplaces (too high without a tilt mount). Confirm height before drilling; it is much harder to fix a too-high mount after the fact.
• Skipping the level check — the mount bracket must be level before the TV is hung. A digital level (or even the level in your phone) on the bracket, not just on the TV, is the correct approach.

What to check in a Calgary TV mounting quote

• Does the quote cover stud locating and bracket assembly, or just the hang?
• Is the mount included, or do you supply it?
• Is cable management (surface, not in-wall) included?
• What happens if no studs are found at the preferred location — does the price change?
• Is the price confirmed before work starts, or is it an estimate that could change on arrival?
• For above-fireplace: does the handyman know to use a tilt mount and check heat clearance?

A reputable handyman in Calgary should be able to quote TV mounting from a photo of your wall and a description of the mount type and TV size. If they cannot give a clear price before showing up, keep looking.

Calgary-specific notes

Calgary new builds (post-2000) almost universally have pre-installed power at TV height in the main living room feature wall and the master bedroom — usually a single duplex outlet at 60 to 66 inches. If your house is newer and there is an outlet at the right height, you are in ideal TV mounting territory.

Older Calgary homes (pre-1990) have more varied wall construction: plaster-and-lath, metal stud in basement development, and occasional structural wood panelling over the original drywall. Always send a photo of the wall when requesting a quote for an older home — what looks like standard drywall occasionally is not.

Calgary's dry climate means drywall anchors set securely and hold their torque well. The wall is not the variable; the mount type and stud position are. Get a photo quote and confirm stud locations before booking.